Philips AVENT Digital Video Baby Monitor SCD603-10 2.4" color screen - Manual (Page 14)

14
Indications on the parent unit
Why doesn’t the battery status symbol appear
on the video display of the parent unit when I
start to charge the parent unit?
• It may take a few minutes before the battery
symbol appears on the video display of the
parent unit when you charge the parent for the
first time or after a long period of disuse.
Why do the battery/power-on light and the
battery symbol on the video display flash red?
• If the battery/power-on light and the
battery symbol on the video display flash
red,the rechargeable battery of the parent unit
is low. Connect the parent unit to an electrical
outlet to recharge the battery (see chapter
‘Preparing for use’).
Why does the parent unit beep?
• If the parent unit beeps while the out-of-
range image appears on the video display, the
connection with the baby unit is lost. Move the
parent unit closer to the baby unit.
• If the parent unit beeps while the battery/
power-on light and the battery symbol on the
video display flash red, the rechargeable battery
of the parent unit is low. Connect the parent
unit to an electrical outlet to recharge the
battery (see chapter ‘Preparing for use’).
• The baby unit may be turned off. Turn on the
baby unit.
Noise/sound
Why does the video monitor produce a high-
pitched noise?
• The units may be too close to each other. Make
sure the parent unit and the baby unit are at
least 1.5 meters (5 feet) away from each other
and set the volume to a lower level.
• The volume of the parent unit may be set too
high. Decrease the volume of the parent unit.
Can I increase the volume of the lullaby on the
baby unit?
• No, you can’t.
• Perhaps the baby unit is not connected to
an electrical outlet and the non-rechargeable
batteries in the baby unit are empty or there
are no non-rechargeable batteries in the baby
unit at all. Connect the baby unit to an electrical
outlet or put new non-rechargeable batteries
in the baby unit. Then set the on/off switch
of the baby unit to ON position to establish
connection with the parent unit.
What happens during a power failure?
• As the parent unit works on a rechargeable
battery, it continues to work if the battery is
sufficiently charged. If you have placed non-
rechargeable batteries in the baby unit, the
camera continues to work and you can see
your baby.
Why do the non-rechargeable batteries of the
baby unit run low quickly?
• The baby unit consumes a lot of energy
when you have the video display turned on
continuously, when you play lullabies or when
the nightlight is turned on. We recommend to
always operate the baby unit while connected
to electricity and to use the batteries for back-
up purpose only. Do not place rechargeable
batteries in the baby unit, as they discharge
slowly even when they are not in use.
Why does the charging time of the parent unit
exceed 2.5 hours?
• The parent unit may be turned on during
charging. Turn off the parent unit during
charging.
Why do I need to keep the baby unit and its
cord at least 1 meter (3.5 feet) from my baby?
• To avoid strangulation with the cord and for
optimal sound detection, always place the baby
unit and its cord at least 1 meter (3.5 feet)
away from the baby.