Philips AVENT Digital Video Baby Monitor SCD603-10 2.4" color screen - Manual (Page 6)

6
4 Using the appliance
1
Place the parent unit and the baby unit in the
same room to test the connection.
Make sure the baby unit is at least 1.5 meters
(5 feet) away from the parent unit.
2
Set the on/off switch on the baby unit to
the ON position.
• The green power-on light goes on.
D Note:
The power-on light always lights up green,
even when there is no connection with
the parent unit.
• When the battery is fully charged, the
battery symbol at the top of the video
display is full.
• When you charge the parent unit for
the first time or after a long period
of disuse, turn it off and let it charge
continuously for at least 4 hours.
• Charging normally takes 2.5 hours, but
it takes longer when the parent unit is
turned on during charging. To keep the
charging time as short as possible, turn off
the parent unit during charging.
• When the rechargeable battery is fully
charged, the parent unit can be used
cordlessly for approx. 7 hours if it is
in voice activation mode. If the video
display is on continuously, the parent unit
can be used cordlessly at default setting
for approx. 5.5 hours.
D Note:
When the parent unit is charged for the first
time, the operating time is less than 7 hours. The
rechargeable battery only reaches its full capacity
after four discharging and charging cycles.
D Note:
The battery gradually discharges, even when the
parent unit is turned off.
D Note:
We advise you to use the parent unit connected
to the mains during the whole night. If the parent
unit runs out of battery, the low battery alert
beeps and this may wake you up.