ARB 3450130 - Manual (Page 13)

Last Rev Date: 19/04/06 Page 13 of 22 Fitting instructions# 3783216
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
40. Remove the fastening screws
and nuts supplied with the turn
signal/clearance lamps and replace
these with the four screws provided
in the kit. Fasten the lamps to the
bar as shown.
IMPORTANT
The turn signal is to the inside of
the bar.
41. Fit M10 caged nuts to inside of
mounting face of bar.
42. If bar is to have a winch fitted,
follow the next steps.
43. Fit number plate bracket using
6mm hardware (20mm x 6m
bolts )
44. Fit control box bracket to bar
using 8mm hardware.
( 20 x 8mm )
45. Fit rubber grommets to top of
bar.
Viewed from the RHS of the inside of bar