ARB 3450130 User Manual
Page 20
Last Rev Date: 19/04/06
Page 20 of 22
Fitting instructions# 3783216
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
70. Light surround is held to bar
using silicon.
71. Apply a bead of silicon
around light cutout on bar and
hold fog light housing to bar
using masking tape until silicon
dries, then remove tape.
72. If fitting fog lights back into
vehicle, pull extended loom
through fog light mounting
bracket and refit black plastic
grommets back into square hole.
73. Reconnect fog light plug back
into light.
74 .Smear grease onto the light
mounting pivots to help when
sliding fog light back into
mounting bracket.
75. NB. When fitting light into
bracket, you must rotate light so
plug fits in between rear of
bracket and vehicle crossmember,
then push light rearward until
light click into bracket mounting
holes.