ARB 3450130 - Manual (Page 15)

Last Rev Date: 19/04/06 Page 15 of 22 Fitting instructions# 3783216
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
49. Lower bar down over winch,
line up top holes first and secure
using 3/8” hardware (1 ½”” x
3/8”bolts) flat and spring washers.
50. Place roller fairlead over lower
holes and again secure using 3/8”
hardware (1 ¾”x 3/8” bolts) flat and
spring washers. When all bolts are
fitted tighten firmly.
51. Fit control box to control box
bracket using original ¼” nuts
from control box and connect
power cables to winch as per winch
instructions.
52. Cable tie power cables clear of
sharp edges and all moving parts.
53. Fit control box earth to winch
tie rods.