ARB 3450130 - Manual (Page 16)

Last Rev Date: 19/04/06 Page 16 of 22 Fitting instructions# 3783216
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
54. Fit M8 caged nuts ( 3 OF ) into
lower section of bar.
( These nuts are to attached air
deflector pan to bar later on. )
55. Fit bar in between chassis
mounting assembly, align slots in
bar to caged nuts in mounting
assembly and secure using M10
bolts ( sems ) assy.
56. Adjust bar to vehicle and
tighten all bolts using socket,
extension and uni joint through fog
light aperture in bar.
57. Bar should have a 10-15mm gap
between bar surround and guard
line.