ARB 3450130 User Manual
Page 4
Last Rev Date: 19/04/06
Page 4 of 22
Fitting instructions# 3783216
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
ASSEMBLY SEQUENCE FOR BULL BAR INSTALLATION.
PLEASE READ AND UNDERSTAND FITTING INSTRUCTIONS BEFORE
ATTEMPTING TO FIT BAR TO VEHICLE
1. Remove grille from vehicle by
removing all plastic clips
Be careful when removing plastic
clips from grille as the plastic clips
are awkward to undo and will be
re used when refitting grille.
Slide flat blade screw driver under
pin of plastic clip and remove pin,
then lift out the plastic clip.
When all clips are removed, pull
grill upward toward you.
2. Remove lower plastic grille
retainer panel from vehicle and put
aside, as this panel will have to be
modified later.
Remove tow hook and crush cans
from vehicle
GRILLE RETAINER PANEL