ARB 3450130 - Manual (Page 9)

Last Rev Date: 19/04/06 Page 9 of 22 Fitting instructions# 3783216
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
22. As viewed from underneath on
LHS of vehicle, align rear hole of
mount assembly to previously
fitted captive nut channel, secure
using M10 bolt x 30mm SEMS (
Bolt, Spring and Flat Washer
ASSY. )
23. Finger tighten only.
24. Carry out fixing to both sides of
vehicle.
NOTE: ‘WARNING’ notes in the
fitting procedure relate to OHS
situations, where to avoid a potentially
hazardous situation it is suggested that
protective safety gear be worn or a safe
work procedure be employed. If these
notes and warnings are not heeded,
injury may result.
25. Using a 10mm drill bit, drill hole
through chassis rail,using hole in
mount as a template. Be careful
not to drill into the nut in captive
nut channel.
26. Secure using bolts same as above,
when all four bolts are fitted,
tighten securely.