ARB 3915030 - Manual (Page 12)

Last Rev Date: 29/10/2008 Page 12 of 24 Fitting instructions# 3783321
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
BAR PREPARATION: FITTING PROCEDURE WINCH
37. Fit the roller fair lead, pull only the end of the
cable through and adjust the position of winch
then bolt up securely. Use the 1 ½” long bolts
in the top and 1 ¾”in the lower set through
the RFL.
Hint: To increase access to mount bolts in front of
roller fairlead, remove circlips from bottom of each
vertical roller shaft, push shaft up so roller can be
dislodged sideways. Do up bolts in fairlead and
winch, then refit circlip.
38. With the aid of another person, turn the bull
bar over so that the back of the bar is
accessible.
39. Connect up the wires to the winch per Warn
handbook (9500lb motor shown top 15000lb
lower views)
NOTE: Refer to the Warn winch handbook for
wiring instructions to vehicle.