Fitting procedure bar on vehicle – ARB 3915030 User Manual
Page 21
Last Rev Date: 29/10/2008
Page 21 of 24
Fitting instructions# 3783321
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE BAR ON VEHICLE
81. Tighten M12x 40mm mounting bolts to
recommended torque
82. Tighten up the M10 brace bolts in 7 places to
recommended torque
64. Using the M10 pilot hole in mount brackets,
drill pinning hole through uprights of bull bar.
Fit M10 SEMS bolt and flange nut, do up tight
to recommended torque.
83. Apply the frame tilt operation label to the top
face of the pan adjacent to the buffer as
shown in diagram
WARNING: LABEL FOR FRAME TILT
OPERATION FOR HOOD CLEARANCE MUST
BE APPLIED TO TOP FACE OF SAHARA
BUMPER IN THE POSITION IDENTIFIED IN
THESE FITTING INSTRUCTIONS. FAILURE TO
APPLY THIS PERMANENT LABEL AT SAHARA
BUMPER FITMENT INDEMNIFIES ARB
CORPORATION OF ANY LIABILITY ARISING
FROM THE OPERATION OR USE OF THIS
PRODUCT.
65. Test the operation of the frame tilt assembly
66. Frame should release from latch and engage
as per the supplied label.
If necessary, adjust the slam latch and or the
bump stops to ensure that the frame complies
and does not have any free play when latched
in the home position yet releases to come
forward with slight backward pressure on top
of tube when lever is pulled forward.
WARNING: THIS FRAME IS NOT DESIGNED
TO SUSTAIN EXCESS LOADING EITHER
FORWARDS OR BACKWARDS, SUCH
LOADS MAY DAMAGE THE FRAME
ASSEMBLY TILT MECHANISM
Warning: Drilling operations can result in
flying metal debris, safety glasses should be
Buffer