Fitting procedure bull bar preparation – ARB 3915030 User Manual
Page 15
Last Rev Date: 29/10/2008
Page 15 of 24
Fitting instructions# 3783321
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE BULL BAR PREPARATION
FITTING NUMBER PLATE
50. If winch fitted, apply double sided tape strip
to top back of number plate. If winch not
fitted, no adhesive strip is required.
51. Fit grommets to slots, with split horizontal as
shown
52. Fit number plate using supplied pan head
screws into grommets.
WITH WINCH
45. Fix using the lower holes in number plate as
shown
WITHOUT WINCH
46. Fix using upper holes in number plate as
shown.
53.
In lower inside face of pan, fit M8 cage
nuts for stone tray in four positions as
shown.
Hint: You can use a flat blade screwdriver to
push the remaining cage nut leg into the hole
IF NOT FITTING WINCH
47. Wrap rubber extrusion around winch cover,
trim to length.
48. Place M6 st stl flat washers over holes in the
top face of the bull bar where the winch cover is
fixed to the bull bar.
NOTE: The M6 washers support the cover and
prevent dipping around the screw heads.
49. Place the winch cover in position as shown with
screws aligning through the mount holes and
leaving the washers in place.
50. Bolt together using the M6 button head
stainless steel screws, washers and M6 nuts.
Split horizontal
The narrower section of the plate is to front
of bull bar