ARB 3915030 - Manual (Page 9)

Last Rev Date: 29/10/2008 Page 9 of 24 Fitting instructions# 3783321
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
REMOVAL OF BUMPER
18. Undo crash bar mounts from chassis flange.
19. Remove crash bar and lower bumper
assembly and set aside, retain flange nuts for
reuse.
20. If parking sensors fitted and are to be
reused, remove from bumper. Also retain
loom tails and set aside.
Note: Remove parking sensor centre from
sleeve first. Then remove sleeve from bumper.
21. Remove bumper cover retaining brackets
from the fenders.
22. Mask up and spray paint the exposed metal
trim area black satin, from the wheel arch
right around to the inboard headlamp area as
shown, both sides of the vehicle.
NOTE: This is in the area where the bumper
cover retaining brackets were removed earlier.
When the bull bar is fitted there will be 25mm of
this sheet metal visible, the black painted finish
masks the visible gap.