ARB 3915030 - Manual (Page 18)

Last Rev Date: 29/10/2008 Page 18 of 24 Fitting instructions# 3783321
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING BUFFERS WITH FRAME
62. Fit the striker pin to the RHS hinge plate and
secure with 5/16”UNC nut and spring washer
as shown and tighten to 22Nm or 16lbft
63. Fit a urethane buffer pad to each of the right
angle brackets using M4x16 csk head screws
and M4 nyloc nuts, to create a pair of RH and
LH assemblies as shown.
64. Tighten the screws until the heads are 1.5mm
below the face of the urethane pad
65. Fit the RHS buffer pad assembly as shown,
wedge of pad up. Secure with 2 x M8 bolts,
washers and flange nut sets. Load bolts from
inboard side of upright, nuts are on bracket
side.
66. With the striker pin engaged fully in the latch
and a slight amount of pressure on the frame
pushing it back against the slam latch, pull
the pad hard against the hinge bracket flange
as shown.
67. Tighten the M8 bolts to recommended torque.
68. Repeat for the LHS
The intention once the assembly is
complete is for the frame to feel solid
without any play.
Screw in until
head is below
surface by 1.5mm