Fitting procedure bar on vehicle – ARB 3915030 User Manual
Page 20
Last Rev Date: 29/10/2008
Page 20 of 24
Fitting instructions# 3783321
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE BAR ON VEHICLE
75. Using two people, three if winch fitted,
position the bar assembly on the vehicle
mounts.
Caution: This product is heavy, especially if a
winch is fitted. Do not attempt to lift it and fit it
by yourself. Have some assistants help you or
use a mechanical aid such as a hydraulic lift
table.
76. Bolt the bar to the mounts using M12 bolts.
Large flat washers and spring washers.
Centralise the bar to the front of the vehicle.
Do not tighten any bolts yet
77. Fit the cross brace to underside of lower pan
and on top of gussets in mount brackets. Use
M10 x 30mm SEMS bolt and washer sets,
flange nuts but do not do up tight. If holes in
pan do not line up, run a Dia 10.0 drill through
any holes to enable bolt entry.
78. Tighten up the mount brackets fasteners.
Start with the tow hook bolts, then M10 flange
nuts to chassis studs.
79. Then tighten up the long M12 chassis studs,
ensuring that the clevis nut is positioned
correctly over the hole in the chassis.
NOTE: Protrusion as shown is approximately
7mm.
80. Adjust the bar height leaving approximately
25mm gap between top of wing to fender.
Align the bar so the front face is vertical and
the gap is even on both sides of the vehicle.
25mm
gap
Warning: Drilling operations can result in
flying metal debris, safety glasses should be