ARB 3915030 - Manual (Page 19)

Last Rev Date: 29/10/2008 Page 19 of 24 Fitting instructions# 3783321
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING BUFFERS WITH FRAME
69. Fit the lever bracket for the slam latch
operation using an M8 x 25 black bolt, nyloc
nut, 2 x M8 flat washers and nylon washer
which is sandwiched between the pan flange
and face of bracket at pivot point.
70. Once M8 nyloc nut is tensioned, bracket must
be able to pivot freely, without play and
without rubbing contact with mounting flange,
adjust accordingly.
71. Fit the plastic rod connector fittings from
underneath into the lever in the slam latch
and from above into the operating bracket
72. Fit the 4mm link rod
73. Fit the spring as shown. It connects to the
lever bracket through the hole in the side and
to a hole in the pan brace at the rear of the
top pan
74. Crimp over the end loops to secure the spring
ends in position
Nylon
washer
Link rod
Spring