ARB 3915030 - Manual (Page 7)

Last Rev Date: 29/10/2008 Page 7 of 24 Fitting instructions# 3783321
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
REMOVAL OF BUMPER
9. Remove push in plugs from trim piece under
headlamp.
10. Carefully prise the trim pieces free by pulling
them forward and twisting to release plugs
out of retaining sockets.
11. Remove screws retaining bumper located
under headlamp area.
12. Remove plugs securing upper bumper tabs.
13. If winch is to be fitted to bull bar, bend the
forward facing section of vertical brace
around and rearwards to prevent interference
from winch operation.