Lukas SC 350 E - Manual (Page 23)

23
9.1 General information
9. Repairs
Servicing may only be carried out by the manufacturer or personnel trained by the
manufacturer and by authorised LUKAS dealers.
Only LUKAS spare parts may be used to replace all components (see spare parts list) since
special tools and compliance with assembly instructions, safety aspects and inspections
must be taken into account (see also chapter "Maintenance and Servicing").
During assembly, make especially sure that all components are clean, since dirt can
damage the rescue tool!
WARNING / CAUTION / ATTENTION!
Protective clothes must be worn when repairs are being carried out, since the
devices may also be pressurised when not in operation.
ATTENTION!
Because LUKAS rescue tools are designed to deliver outstanding performance,
components must only be replaced with those that are listed in the spare parts
lists for the corresponding device.
Other components in the device may only be replaced if:
- you have participated in an appropriate LUKAS service training course.
- you have the express permission of LUKAS Customer Service (valid LUKAS
certifi cate necessary!)
8.2 Safety equipment
• Check of the protective equipment on / around the rescue equipment, especially the hand
guard for the moveable parts (this must be free of cracks!).
Battery and power supply
• Casing
undamaged,
• Electrical contact surfaces clean and undamaged
• Cable
undamaged
• Battery(-ies) fully charged (when used)
• Charging state display of lithium/ion battery(-ies) fully functional
Functional check
• Easy opening and closing or extension/retraction of star grip controls,
• no suspicious noises.
• no further movement of cutter and spreader arms or cylinder piston when interrupting the
valve function during the process (dead man's switch),
NOTE:
Always register your tool on the LUKAS Hydraulik GmbH internet site. Only then
are you entitled to the extended guarantee.