Lukas SC 350 E - Manual (Page 34)

34
NOTE:
The torque required can be taken from the spare parts list of your particular unit.
ATTENTION!
Don’t forget to apply LUKAS special grease to all sliding surfaces.
8. The work steps must be carried out in reverse order to fi t the new parts.
9.3.5 Rescue ram
Work steps for exchanging the cylinder piston claw:
1. First of all, carefully clean the rescue equipment. Now switch off the device and remove
the battery or unplug the power supply from the device.
2. Pull the claw "A" off the cylinder piston
and remove the O-ring "B". Where the
O-ring is damaged, it must be replaced.
3. Insert the O-ring "B" into the groove of the new claw "A" provided and check it for a fi rm
fi t. Grease the contact surfaces with LUKAS special grease and thenslide the new claw
onto the cylinder piston up to the limit stop.
A B
Work steps for exchanging the cylinder base claw:
1. First of all, carefully clean the rescue equipment. Now switch off the device and remove
the battery or unplug the power supply from the device.
2. Pull the claw "C" off the cylinder base
and check whether the O-ring "D" in the
cylinder base has been damaged; if yes,
replace it.
3. Check the fi rm fi t of the O-ring "D", grease the contact surfaces with LUKAS special
grease and then slide the new claw "C" onto the cylinder base up to the stop.
D C