Lukas P 600 OE - Manual (Page 19)

19
8. Dismantling the equipment / deactivation
following operation
Procedure:
1. When the work is completed, the connected units must be returned to the starting
position.
This should mean that the hydraulic tank on the P600OE has the starting volume of
hydraulic fl uid.
2. Then switch off the device at the main switch.
3. Separate the connected unit from the hydraulic unit.
4. After each use, the pump must be cleaned externally and wiped down with a damp cloth.
Connection slot
NOTE:
You should not store the hydraulic unit for several weeks with the battery
in place.
Bear in mind that, if the unit is stored for an extended period, the hydraulic
fl uid in the tank will age and needs to be replaced at regular intervals .
Do not store the pump, the battery and the mains power unit in a damp or
dusty environment!
5. Unplug the power supply (if used) by pulling the mains plug.
6. Fully press down the two unlocking buttons and carefully pull the battery or power
supply out of the device.
Do not use force!
CAUTION!
The electric contacts in the connection slot, on the battery and on the
mains power unit must not be cleaned with damp cloths! There are suitable
agents to provide corrosion protection for the electrical contacts.