Lukas P 600 OE - Manual (Page 22)

22
10.1 General points
10. Maintenance and repair
WARNING / CAUTION / ATTENTION!
Protective clothes must be worn when repairs are being carried out, since the
devices may also be pressurised when not in operation.
NOTE:
Always register your tool on the LUKAS Hydraulik GmbH internet site. Only then
are you entitled to the extended guarantee.
10.2 Preventive maintenance
10.2.1 Care instructions
The unit should be cleaned externally with a damp cloth from time to time (not the electrical
contacts in the connection slot, on the battery and on the mains unit)
There are special agents for treating the electrical contacts, that are suitable for cleaning and
providing corrosion protection for the electrical contacts. Use must only use these agents on
the contacts.
(In case of doubt, contact your authorised LUKAS dealer or LUKAS directly!)
10.2.2 Functional and stress test
If there is any doubt regarding the safety or reliability of the equipment, a function and stress
test must also be performed.
LUKAS offers appropriate testing equipment for this.
Because of the complex construction and the high hydraulic pressure, repair work must
only be carried out by the unit manufacturer or by personnel specially trained by the unit
manufacturer and by authorised LUKAS dealers.
For these reasons, only simple maintenance work is listed in this manual.
Components of the unit must only ever be replaced by genuine LUKAS spare parts.
The components that can be replaced are shown in the spare parts list. Also, any necessary
special tools, installation instructions, safety aspects, tests that always need to be observed
can be found in the spare parts list.
During assembly, make especially sure that all components are clean, since dirt can
damage the rescue tool!