Lukas P 600 OE - Manual (Page 24)

24
3. Pour the hydraulic fl uid into a suitable collection vessel.
4. Place the P600OE on level, fl at ground and fi ll up to the maximum mark.
5. Then close the tank again with the fi ller cap and insert the battery into the connection
slot or connect the pump to the power supply.
6. Switch the pump on and let it run for approx. 2-3 minutes. This bleeds the pump.
7. Check the level in the tank again and top up if necessary.
8. Then
fi t the fi ller cover back in place and close off the tank access on the unit.