IKA A 11 basic - Manual (Page 13)

13
Contents EN
CE-Declaration of conformity
We declare under our sole responsibility that this product corrosponds to the
regulations 89/336/EC, 73/23/EC and 98/37/EC and conforms with the standards
or standardized documents DIN EN IEC 61 010-1, DIN EN IEC 61 326-1,
DIN EN ISO 12100-1,-2 and EN 60 204-1.
Safety instructions
Page
CE-Declaration of conformity 13
Safety instructions 13
Correct use 14
Unpacking 14
Useful facts 14
Commissioning 16
Malfunctions and eliminating malfunctions 17
Maintenance and cleaning 19
Accessories 20
Warranty 21
Technical data 21
List of spare parts A 11 basic 56
Spare parts diagram A 11 basic 57
In order to be able to use the appliance properly and safely, every user
must first read the operating instructions and observe the safety instruc-
tions contained therein. Take care of these operating instructions and
keep them in a place where they can be accessed by everyone.
Only staff who have been trained accordingly, know the appliance and are
authorised to carry out work in this field should use this appliance.
The machine may only be openend by trained specialists - even during repairs. The
machine is to be unplugged from the mains before opening. Live parts inside the
machine may still be live for some time after unplugging from the mains.
The appliance can only be disconnected from the mains supply by pulling out the
mains plug or the connector plug. The socket for the mains cord must be easily
accessible.
Please follow the relevant safety instructions and guidelines, and occupational
health and safety regulations for use in the laboratory. When working with the mill,
the user must wear his personal protective equipment. Defective or inappropriate
protective equipment can expose the user to the risk of spurting substances.
Please make certain that the mill is not tilted when it is in operation and hold it in
place with both hands.
Please ensure that there are no parts of the body between the casing parts that
move together.
Caution: Before removing the grinding beaker, switch off the mill and wait until
the motor stops. Risk posed by trailing crushing elements (beaters or cutters).
Always switch off the appliance and disconnect the plug before cleaning or
replacing parts.
Caution: The grinding beaker, crushing elements and rotor shaft may be hot
after long grinding cycles. Allow the mill to cool down before cleaning or before
changing crushing elements.
Caution: Beware of the sharp - edged cutter in particular when changing crushing
elements and when cleaning. Always wear your personal protective equipment
(protective gloves, etc.).
Please note that wear debris from the appliance or rotating accessories can end up
in the medium to be processed. Please contact IKA should you have any questions
in this respect.
These operating instructions apply to all IKA- S versions
(e.g. A 11 basic S 001).