JLG 80SL Service Manual - Manual (Page 59)

SECTION 3 - CHASSIS, PLATFORM & SCISSOR ARMS
3121325 – JLG Lift – 3-23
Pressure Filter
Removal:
1. Disconnect hose(s) from the Pressure Filter (1).
2. Loosen and remove the four Capscrews (2) and
Lockwashers (3).
3. Remove the Pressure Filter.
NOTE: Replace filter every 250 hours of operation.
Installation:
1. Align the pressure filter so that the screw holes
match up with the screw holes on the holding
bracket.
NOTE: Be sure arrow on top of filter points towards the
hydraulic tank.
2. Insert the four Lockwashers and Capscrews into the
holes and tighten.
3. Reconnect any hose(s) disconnected during
removal.
1 2, 3
1. Pressure Filter 2. Capscrew, M10 x 20mm 3. Lockwasher, M10
Figure 3-21. Pressure Filter Removal