JLG 80SL Service Manual - Manual (Page 68)

SECTION 3 - CHASSIS, PLATFORM & SCISSOR ARMS
3-32 – JLG Lift – 3121325
Platform Extension Side Rails
THE EXTENSION SIDE RAILS WEIGH APPROXIMATELY 58 LBS
(26.2 KG) EACH. USE CAUTION WHEN REMOVING ANY PLAT-
FORM RAIL.
NOTE: All procedures apply to the opposite side.
Removal:
1. Disconnect Side Rails (1) from end rail by removing
Cotter Pin (2) from Pin (3).
NOTE: The Chain Assembly/Pin/Cotter Pin can be removed
by removing the Bolt (4), Lockwasher (5), and Flat-
washer (6).
2. Remove the Cotter Pins (8) from the Pins (9) on
each Bracket (10). Pull the pin out of the bracket.
3. Carefully fold rails inward to the stowed position.
4. Remove the Bolts (11), Locknuts (13), Flatwashers
(12), and Chain Assembly Mounting Plates (14).
The rail can now be removed.
Installation:
NOTE: Place the rail(s) on the platform in their stowed posi-
tion when installing.
1. Follow the removal instructions in reverse order.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
1. Extension Side Rail
2. Cotter Pin
3. Pin
4. Bolt, M6 x 16mm
5. Lockwasher, M6
6. Flatwasher, M6
7. Chain Assembly Mounting Plate
8. Cotter Pin
9. Pin
10. Extension Rail Bracket
11. Bolt, M12 x 100mm
12. Flatwasher, M12
13. Locknut, M12
14. Chain Assembly Mounting Plate
15. Bolt, M10 x 25mm
16. Lockwasher, M10
Figure 3-30. Extension Side Rails Removal