JLG LiftPOD FS80 (1001070451) - Manual (Page 14)

SECTION 1 - SAFETY PRECAUTIONS
1001070451 LIFTPOD by JLG 1-877-254-3876
1-4 www.liftpod.com 1-877-2-LIFTPOD
• Do not allow ropes to contact surfaces with a temperature
higher than 60°C/140°F
• When performing welding, cutting or grinding operations,
avoid direct contact of heat, sparks and debris with the
ropes and carriage drive assembly.
• Charge batteries only in a well ventilated area.
This machine is a powered personnel lift equipped with a work
platform that travels up and down a mast. Vibrations emitted by
this machine is not hazardous to an operator in the work platform.
The equivalent continuous A-Weighted sound pressure level at the
work platform is less than 70dB(A).
Trip and Fall Hazard
• Do not enter or leave the platform while elevated.
• JLG recommends that the operator utilises a fall restraint
system in the platform with a maximum 36 inch (91.4cm)
lanyard attached to the authorised lanyard anchorage
point. For further information regarding fall protection
requirements on JLG products, contact JLG.
• Before operating the machine, make sure all railings and
gates are fastened in their proper position.
• Keep both feet firmly positioned on the platform floor at all
times. Never use ladders, boxes, steps, planks, or similar
items on platform to provide additional reach.
• Never use the mast assembly to enter or leave the plat-
form.
MAX = 36 in (91.4cm)
FS.book Page 4 Tuesday, May 10, 2011 3:15 PM