Examples of new, acceptable and unacceptable, Ropes -7, Ropes retained in mast cap -7 – JLG LiftPOD FS80 (1001070451) User Manual
Page 25: Rope anchor points -7, Figure 2-4.). ens, P (figure 2-5.) a, St (figure 2-6.), Figure 2-4.)
SECTION 2 - PREPARATION AND INSPECTION
1-877-254-3876
LIFTPOD by JLG
1001070451
1-877-2-LIFTPOD
www.liftpod.com
2-7
legible; emergency stop switch reset for operation; con-
trol markings legible. Battery is installed and secure.
10. Platform Assembly and Gate - Check mounting pins
are not loose; platform railing is undamaged; platform
latch is engaged on carriage (Figure 2-7.); self-closing
entry gates are in proper working order; no cracks or
corrosion visible.
11. Tool Tray - See next page for Tool Tray Pre-Start Inspec-
tion Procedure.
Figure 2-4. Examples of new, acceptable and
unacceptable ropes
Figure 2-5. Ropes retained in mast cap
Figure 2-6. Rope anchor points
Check both ropes
are retained in
groove in cap
Mast
Mast Cap
Check that each termination is
engaged under its anchor point
by viewing through the cover.
The two upper rope tails
should be slack.
The lower rope loop should
be tight around anchor.
Top of
Mast
FS.book Page 7 Tuesday, May 10, 2011 3:15 PM