Table 7-1. troubleshooting, Troubleshooting -4 – JLG LiftPOD FS80 (1001070451) User Manual

Page 90

Advertising
background image

SECTION 7 - TROUBLESHOOTING

1001070451

LIFTPOD by JLG

1-877-254-3876

7-4

www.liftpod.com

1-877-2-LIFTPOD

Table 7-1. Troubleshooting

Castor is damaged

Replace castor.

Base will not level (DO NOT ELEVATE UNLESS BASE IS FIRM AND LEVEL)

Castor deployed

With no load in platform and people clear of adjustable feet - exert approximately
25kg pressure onto front of base. Castor should retract. Adjustable feet should
then be able to be used to level the machine on slopes less than 2 degrees front to
back. Do not use the machine on any side slope.

Machine rocks slightly side to side

Support surface is not level

Only use the machine on firm and level surfaces.

Adjustable feet are not BOTH in contact with
supporting surface

Adjust the feet so that BOTH feet are in firm contact with supporting surface AND
the machine is level.

Ropes are worn or a rope is broken or machine is 5 years old or machine has been in service for 5 years since previous service

Damage or wear or machine is 5 years old

Deliver unit to an Authorized JLG Service Center for replacement.

Platform will not lift full rated load

Battery not fully charged

Charge or replace battery.

Overload clutch is slipping

Contact Authorized JLG Service Center.

TROUBLE

PROBABLE CAUSE

REMEDY

FS.book Page 4 Tuesday, May 10, 2011 3:15 PM

Advertising
This manual is related to the following products: