JLG LiftPOD FS80 (1001070451) - Manual (Page 41)

SECTION 3 - MACHINE OPERATION
1-877-254-3876 LIFTPOD by JLG 1001070451
1-877-2-LIFTPOD www.liftpod.com 3-13
Fast Charge Indicator Light Guide
SOLID GREEN: Insert battery or remove fully charged battery
FLASHING GREEN: Battery is charging.
SOLID RED: Charging is temporarily halted to allow battery to
cool down. Charging will continue automatically.
FLASHING RED: Please reinsert battery. If the red light continues
to flash, the battery or the charger may be faulty.
To troubleshoot whether the battery or the charger is at fault, insert
another battery. If this battery charges, the other battery is faulty
and must not be used. If the red light continues to flash, the
charger is faulty.
Power Supply Cord
Below is the specification of the power supply chord to be used
with the fast charger within the U.S.A.
Use UL listed detachable power supply cord - No. 18 AWG, two
conductors, VW-1, 221°F (105°C), 125V, Type:SPT-2, minimum 5 ft.
11 in. (1.8m), maximum 9 ft. 10 in. (3m) long. Provided with a
molded-on, polarized attachment plug with a 15A, 125V (NEMA 1-
15P) configuration and a molded-on connector which mates with
the power inlet.
3.5 Operation
Cordless Drill
1. Drive Socket (optional)
2. Chuck
3. Torque Control (optional)
4. Power Trigger
5. Speed Controller (optional)
6. Drill/Hammer Function Selector (optional)
Figure 3-18. Typical cordless drill interface devices
7
3
2
8
5
6
1
4
FS.book Page 13 Tuesday, May 10, 2011 3:15 PM