JLG LiftPOD FS80 (1001070451) - Manual (Page 89)

SECTION 7 - TROUBLESHOOTING
1-877-254-3876 LIFTPOD by JLG 1001070451
1-877-2-LIFTPOD www.liftpod.com 7-3
Platform will not move when in elevated position - motor starts
Driveshaft interlock is engaged Push cordless drill on driveshaft down firmly to disengage driveshaft safety inter-
lock.
(If using powerpack) Powerpack shaft not
engaged Check powerpack charged and in correctly fitted and is fully down and latched
down.
Drive shaft malfunction Lower platform using manual descent procedure (see Section 4.1). Refer to
Authorized JLG Service Center.
No load in platform & will not lower If carriage is not within 1m (3 ft) of the base of the mast contact Authorized JLG
Service Center. If carriage is within 1m (3ft) from ground, apply load in platform,
drive up 1", then drive down.
Ropes are loose (ropes must never be loose)
Machine was disassembled without platform
being fully lowered to engage the carriage lock
down latch. Carriage then moved up the mast
loosening the ropes If carriage is not within 1m (3 ft) of the base of the mast contact Authorized JLG
Service Center. Otherwise follow rope re-tensioning procedure detailed in Section
6.7, point 3. Ensure both ropes are tight and remain so at all times.
Machine does not wheel properly
Retractable Swivel Castor is not properly
deployed With no load in the platform or on the base - lift the castor deploy handle on front of
base, adjacent to platform gate. Castor should deploy and lift front of machine off
adjustable feet to allow machine to roll easily on rear wheels and front castor.
TROUBLE PROBABLE CAUSE REMEDY
FS.book Page 3 Tuesday, May 10, 2011 3:15 PM