JLG LiftPOD FS80 (1001070451) - Manual (Page 23)

SECTION 2 - PREPARATION AND INSPECTION
1-877-254-3876 LIFTPOD by JLG 1001070451
1-877-2-LIFTPOD www.liftpod.com 2-5
Walk-Around Inspection Components NOTE: On all components, make sure there are no loose or miss-
ing parts, everything is securely fastened, no visible dam-
age, or excessive wear exists in addition to any other
criteria mentioned.
1. Rear Wheels - Check for any debris stuck to or around
wheels. Make sure bolts are fastened. Make sure castor
locks operate properly (if equipped).
2. Base Frame - Check for cracks or corrosion, especially
around the mast-stump base (see Figure 2-2.). Check
level bubble is clean and secure.
3. Mast Assembly - No cracks or corrosion, especially
around base and flange; no excess wear, kinks, nicks or
damage; carriage running surfaces smooth and unob-
structed; free of dust, oil & grease.
4. Carriage Frame - check for visible cracks; check rollers
for visible wear; check carriage frame welds for visible
cracks (see Figure 2-2.).
5. Gearbox - check for any oil leaks, especially around
bottom shaft seal.
6. Swivel Castor Mechanism and Adjustable Feet -
Check for any debris stuck to or around wheels or
mechanism. Check adjustable feet for damage. Rubber
pads and tire must be in good order.
Figure 2-1. Daily Walk-Around Inspection
(Sheet 1 of 2)
1
2
3
4
REAR
FRONT
(FS80 base shown)
FS.book Page 5 Tuesday, May 10, 2011 3:15 PM