JLG LiftPOD FS80 (1001070451) - Manual (Page 43)

SECTION 3 - MACHINE OPERATION
1-877-254-3876 LIFTPOD by JLG 1001070451
1-877-2-LIFTPOD www.liftpod.com 3-15
The powerpack is splash resistant allowing a safe descent if it
starts to rain while the unit is elevated, but JLG does not recom-
mend that the powerpack be used in rain or exposed to water.
Whenever the machine is not in use, set the direction selector to
the OFF position.
DISCONTINUE USE OF THE POWERPACK IF A FAULT IS DETECTED.
NOTICE
DO NOT PRESSURE-WASH THE POWERPACK.
MAKE SURE YOU CHECK THE REMAINING CHARGE INSIDE THE POW-
ERPACK’S BATTERY BEFORE ELEVATING THE PLATFORM BY PRESSING
THE CHARGE INDICATOR TEST BUTTON. IF ONLY ONE LIGHT COMES
ON, REPLACE WITH FULLY CHARGED BATTERY.
NOTICE
IF THE POWERPACK DOES NOT ACTIVATE WITH A CHARGED BATTERY
INSTALLED, THE EMERGENCY BUTTON MAY NEED TO BE RESET
(TWIST IN DIRECTION OF ARROWS AND POP OUT).
Elevating
Make sure the pre-start inspection has been completed, the
machine is safe to use, and the base is level.
Move the cordless drill’s direction selector to the "screw-in" (clock-
wise) direction.
Hold the drill’s handle firmly, push it down to automatically disen-
gage the driveshaft interlock, and squeeze the trigger to elevate.
Stop using the cordless drill if any part of it becomes excessively
hot. Wait until drill has cooled down and then continue operation.
Figure 3-20. Cordless drill elevation
FS.book Page 15 Tuesday, May 10, 2011 3:15 PM