6 decal replacement, Decal replacement -12 – JLG LiftPOD FS80 (1001070451) User Manual
Page 82
SECTION 6 - SERVICE AND MAINTENANCE
1001070451
LIFTPOD by JLG
1-877-254-3876
6-12
www.liftpod.com
1-877-2-LIFTPOD
6.6 Decal Replacement
All decals must be mounted to the machine as specified and be
clearly legible.
Please see Figure 5-1. to Figure 5-4 and refer to Table 5-1. for
positions and JLG part numbers.
To replace a damaged decal, first remove it completely, without
damaging the underlying surface.
Remove any remaining adhesive with a suitable solvent. Test sol-
vent on inconspicuous area first, to ensure it does not mark or
damage the underlying surface finish.
NOTICE
SURFACE DAMAGE COULD RESULT IN CORROSION AND STRUCTURAL
DAMAGE.
Before applying new decal, ensure the surface is clean and dry.
Remove backing paper, apply decal along one edge then seat it
gently and evenly.
If there are any air bubbles, work them gently towards the edge
with a clean cloth.
Pressure sensitive adhesive reaches full strength after a several
days.
FS.book Page 12 Tuesday, May 10, 2011 3:15 PM