JLG E45A_AJ ANSI Service Manual - Manual (Page 16)

SECTION 1 - SPECIFICATIONS
1-8 – JLG Lift – 3120765
Table 1-8. Lubrication Chart
Components
Number/Type
Lube Points
Capacity Lube
Interval Hours
Comments
3 Months
150 hrs
6 Months
300 hrs
1 Year
600 hrs
2 Years
1200 hrs
Lubrication
1 Swing Bearing 1 Grease Fitting or by
brush
A/R MPG X More frequent lubrication intervals may be
required
2 Swing Bearing /
Worm Gear Teeth* Spray On A/R Mobiltac
375NC
X More frequent lubrication intervals may be
required.
3 Hydraulic Fluid (Oil) Fill Cap 4 Gal. (tank) HO X Check oil every 10 hours of operation.
Change oil every 1200 hours of operation.
4 Hydraulic Filter N/A N/A N/A X Replace filter element after first 50 hours and
every 300 hours thereafter.**
5 Wheel Drive Hub Fill Plug/Half Full 17 oz. (1/2 Full) EPGL X Check oil level at side plug on hub daily.
Change after first 150 hours then every 1200
hours of operation.
6 Wheel Bearing Repack A/R MPG X
7 Spindles/Bushing N/A A/R LL At Spindle/Bushing Replacement Coat I.D. of bushings prior to installing king
pins.
8 Boom Pivot Pins/
Bushing N/A A/R LL At boom pivot pins/bushing replacement Coat I.D. of bushings prior to installing pins.
9 Engine Fill Cap Refer to Engine
Manual
EO Check daily. Change in accordance with
engine manual.
NOTES: KEY TO LUBRICANTS
Lubrication intervals are based on machine operation under normal conditions. For machines used in multi shift operations and/or exposed to hostile
environments or conditions, lubrication frequencies must be increased accordingly. EO
EPGL
HO
MPG
Engine Oil
Extreme Pressure Gear Lube
Hydraulic Fluid (Mobil DTE-11M)
Multi-Purpose Grease
* If necessary install grease fittings into worm gear housing and grease bearings.
DO NOT OVERGREASE BEARINGS. OVERGREASING BEARINGS WILL RESULT IN
BLOWING OUTER SEAL IN HOUSING.
** Under certain conditions, it may be necessary to replace the hydraulic filter on a more frequent basis. A common symptom of a dirty filter is sluggish-
ness experienced in hydraulic functions.