JLG E45A_AJ ANSI Service Manual - Manual (Page 19)

SECTION 2 - PROCEDURES
3120765 – JLG Lift – 2-3
2.3 LUBRICATION INFORMATION
Hydraulic System
1. The primary enemy of a hydraulic system is contam-
ination. Contaminants enter the system by various
means, e.g.; inadequate hydraulic oil, allowing mois-
ture, grease, filings, sealing components, sand, etc.
to enter when performing maintenance, or by per-
mitting the pump to cavitate due to insufficient sys-
tem warm-up.
2. The design and manufacturing tolerances of the
component working parts are very close, therefore,
even the smallest amount of dirt or foreign matter
entering a system can cause wear or damage to the
components and generally results in faulty opera-
tion. Every precaution must be taken to keep
hydraulic oil clean, including reserve oil in storage.
Hydraulic system filters should be checked,
cleaned, and/or replaced at the specified intervals
required in Section 1. Always examine filters for evi-
dence of metal particles.
3. Cloudy oils indicate a high moisture content which
permits organic growth, resulting in oxidation or cor-
rosion. If this condition occurs, the system must be
drained, flushed, and refilled with clean oil.
4. It is not advisable to mix oils of different brands or
types, as they may not contain the same required
additives or be of comparable viscosities. Good
grade mineral oils, with viscosities suited to the
ambient temperatures in which the machine is oper-
ating, are recommended for use.
NOTE: Metal particles may appear in the oil or filters of new
machines due to the wear-in of meshing compo-
nents.
Hydraulic Oil
1. Refer to Section 1 for recommendations for viscosity
ranges.
2. JLG recommends Mobil DTE-11 Hydraulic Oil, which
has an SAE viscosity of 10W and a viscosity index of
140.
NOTE: Start-up of hydraulic system with oil temperatures
below -20 degrees F. is not recommended. If it is
necessary to start the system in a sub-zero environ-
ment, it will be necessary to heat the oil with a low
density 100VAC heater to a minimum temperature of
-20 degrees F.
Changing Hydraulic Oil
1. Use of any of the recommended hydraulic oils elimi-
nates the need for changing the oil on a regular
basis. However, filter elements must be changed
after the first 50 hours of operation and every 300
hours thereafter. If it is necessary to change the oil,
use only those oils meeting or exceeding the specifi-
cations appearing in this manual. If unable to obtain
the same type of oil supplied with the machine, con-
sult local supplier for assistance in selecting the
proper equivalent. Avoid mixing petroleum and syn-
thetic base oils. JLG Industries recommends chang-
ing the hydraulic oil every two years.
2. Use every precaution to keep the hydraulic oil clean.
If the oil must be poured from the original container
into another, be sure to clean all possible contami-
nants from the service container. Always clean the
mesh element of the filter and replace the cartridge
any time the system oil is changed.
3. While the unit is shut down, a good preventive main-
tenance measure is to make a thorough inspection
of all hydraulic components, lines, fittings, etc., as
well as a functional check of each system, before
placing the machine back in service.
Lubrication Specifications
Specified lubricants, as recommended by the component
manufacturers, are always the best choice, however,
multi-purpose greases usually have the qualities which
meet a variety of single purpose requirements. Should
any question arise regarding the use of greases in mainte-
nance stock, consult your local supplier for evaluation.
Refer to Section 1 for an explanation of the lubricant key
designations appearing in the Lubrication Chart.