JLG 600A_AJ Service Manual User Manual
Page 104
SECTION 3 - CHASSIS & TURNTABLE
3-54
– JLG Lift –
3121201
4. Place second set of sixteen needle rollers into clus-
ter gear.
5. Apply grease or petroleum jelly to the tang side of
two thrust washers. Place thrust washers against
bosses in carrier with washer tang fitting into slot in
carrier outside diameter.
NOTE: Some old style carriers will not have slots and tangs
should be located inside boss relief.
6. While keeping thrust washers in place, slide cluster
gear into carrier with the larger gear on the side with
the small pin hole.
7. Line up cluster gear and thrust washer with hole in
carrier and slide planet shaft through. Line up cham-
fered side of hole in planet shaft with pin hole in car-
rier.
8. Drive anti-roll pin flush into carrier hole, thereby lock-
ing planet shaft into place.
Repeat these steps for remaining two cluster gears
to complete carrier assembly.