JLG 601S ANSI Service Manual - Manual (Page 48)

SECTION 3 - CHASSIS & TURNTABLE
3-8 – JLG Lift – 3120746
21. Place o-ring (22) into cover assembly counter bore.
Use petroleum jelly or grease to hold o-ring in place.
22. Place cover assembly over ring gear with oil level
check plug in cover located approximately 90
degrees from oil fill plug in hub.
23. Locate four shoulder bolts (42), 90 degrees apart
into counter bored holes in hub marked in step (13).
Torque shoulder bolts to 47 ft. lbs. (64 Nm).
24. Install bolts (41) in remaining holes. Torque bolts to
64 Nm (47 ft. lbs.).
25. Place coupling (1) into spindle and onto input shaft.
26. Fill hub one-half full of EPGL 90 lubricant before
operation.