JLG 601S ANSI Service Manual - Manual (Page 96)

SECTION 3 - CHASSIS & TURNTABLE
3-56 – JLG Lift – 3120746
3.15 TILT ALARM SWITCH (MACHINES WITH
EXTERNAL TILT SENSOR)
PERFORM TILT ALARM SWITCH LEVELING PROCEDURE A MINI-
MUM OF EVERY SIX MONTHS TO ENSURE PROPER OPERATION
AND ADJUSTMENT OF SWITCH.
Manual Adjustment
1. Park the machine on a flat, level surface. Ensure
machine is level and tires are filled to rated pressure.
NOTE: Ensure switch mounting bracket is level and securely
attached.
2. Level the base of the indicator by tightening the
three flange nuts through approximately one quarter
of its spring travel. DO NOT ADJUST THE “X” NUT
DURING THE REMAINDER OF THE PROCEDURE.
3. With the electrical connections complete, using bub-
ble level on top of indicator, slowly tighten or loosen
the three flange nuts until indicator is level.
4. Individually push down on one corner at a time;
there should be enough travel to cause the switch to
trip. If the switch does not trip in all three tests, the
flange nuts have been tightened too far. Loosen the
“X” nut and repeat steps (2). through (4).
3.16 SPARK ARRESTER CLEANING
INSTRUCTIONS
1. Remove the cleanout plug in the bottom of spark
arrester (muffler).
2. Without causing deformation (or any type of dam-
age to the spark arrester) repeatedly tap on the
arrester near the cleanout plug. This may be enough
to begin drainage of the spark trap.
3. An industrial vacuum cleaner can do a complete job
at this point.
a. Or, IN A SAFE AREA, start the engine. Then
alternate between low idle and high idle for two
to three minutes.
b. Or, operate the engine as required by the appli-
cation for two to three minutes.
4. Install the cleanout plug. (See Table 2-4. Preventive
Maintenance and Inspection Schedule.
3.17 DUAL FUEL SYSTEM
IT IS POSSIBLE TO SWITCH FROM ONE FUEL SOURCE TO THE
OTHER WITHOUT ALLOWING THE ENGINE TO STOP. EXTREME
CARE MUST BE TAKEN AND THE FOLLOWING INSTRUCTIONS
MUST BE FOLLOWED.
Changing from Gasoline to LP Gas
1. Start the engine from the ground control station.
2. Open the hand valve on the LP gas supply tank by
turning counterclockwise.
BE SURE ALL GASOLINE IS EXHAUSTED BEFORE SWITCHING
TO LP GAS.
3. While the engine is operating, place the three posi-
tion LPG/Gasoline switch at the ground control sta-
tion to the center “off” position. Allow the engine to
operate without load, until the engine begins to
“stumble” from lack of gasoline.
4. As the engine begins to “stumble”, place the switch
to the LPG position, allowing the LP fuel to be sent
to the fuel regulator.
Figure 3-43. Tilt Switch Adjustment