JLG M600 Service Manual - Manual (Page 128)

SECTION 4 - BOOM & PLATFORM
4-18 – JLG Lift – 3121813
10. Remove the shaft (2). It may be necessary to strike
the threaded end of the shaft with a rubber mallet.
11. Before removing the piston (3), mark the housing (1)
ring gear in relation to the piston O.D. gear. There
should now be timing marks on the housing (1) ring
gear, the piston (3) and the shaft (2).
12. To remove the piston (3) use a rubber mallet and a
plastic mandrel so the piston is not damaged.
13. At the point when the piston gear teeth come out of
engagement with the housing gear teeth, mark the
piston and housing with a marker as shown.
14. Remove the o-ring (204) and backup ring (207) from
end cap (4) and set aside for inspection.
15. Remove the wear guides (302) from the end cap (4)
and shaft (2).