7 function speeds, Machine orientation when doing speed tests, Test notes – JLG M600 Service Manual User Manual

Page 16: 8 pressure settings, Function speeds -2, Pressure settings -2

Advertising
background image

SECTION 1 - SPECIFICATIONS

1-2

– JLG Lift –

3121813

1.7 FUNCTION SPEEDS

Machine Orientation When Doing Speed
Tests

Lift: Boom Retracted. Telescope Retracted. Lift Up,
Record Time, Lift Down, Record Time.

Swing: Boom at Full Elevation. Telescope Retracted.
Swing the Turntable to the end stop. Swing the Opposite
Direction, Record Time.

Telescope: Boom at Full Elevation; Telescope Retracted;
Telescope Out, Record Time. Telescope In, Record Time.

Drive: Test to be done on a smooth level surface. Start
approximately 25 ft. (7.62 m) from starting point so that
the unit is at maximum speed when starting the test.
Results should be recorded for a 200 ft. (60.96 m) course.
Drive Forward, record time. Drive Reverse, Record Time.

Drive (Above Horizontal): Test should be done on a
smooth level surface. The Platform Speed Knob should be
selected out of the creep speed. This verifies that the
switches are working when the boom is above horizontal.
Results should be recorded for a 50 ft. course. Drive For-
ward, Record Time. Drive Reverse, Record Time.

Platform Rotate: Platform level and completely rotated
one direction. Rotate the opposite direction, Record Time.
Rotate the other direction, Record Time.

Articulating Jib: Platform level and centered with the
boom. Start with the Jib down. Jib Up, Record Time. Jib
Down, Record Time.

Test Notes

1. Stop watch should be started with the function, not

with the controller or switch.

2. Drive test results reflect 36/14LL-22.5 tires.

3. All speed tests are run from the platform. These

speeds do not reflect the ground control operation.

4. The platform speed knob control must be at full

speed (turned clockwise completely).

5. Function speeds may vary due to cold, thick hydrau-

lic oil. Test should be run with the oil temperature
above 100° F (38° C).

6. Some flow control functions may not work with the

speed knob clicked into the creep position.

1.8 PRESSURE SETTINGS

Table 1-7. Function Speeds

Lift Up

55-61

Lift Down

55-61

Swing Right & Left

72-84

Telescope Out

46-50

Telescope In

46-50

Platform Rotate Left & Right

24-26

Jib Up

25-27

Jib Down

21-23

Jib Swing

30-40

High Drive (200 ft.)

42-46 (3.0 mph)

Drive above Horizontal (50 ft.)

65-71 (0.5 mph)

4150273-N

Table 1-8. Pressure Settings

SETTING

PSI

BAR

Proportional Main Relief

3200

220

Bang Bang Main Relief

3000

207

Lift Up

2500

172

Lift Down

1100

76

Swing

2500

172

Swing Brake

320

22

Steer

1800

124

Platform Level Up

2500

172

Platform Level Down

1500

103

Jib Up

2300

158.5

Jib Down

2300

158.5

Advertising
This manual is related to the following products: