2N Analogue GSM gateway 2N EasyGate - Manual, 1575 v1.1.0.2 - Manual (Page 33)

Table of Parameters 3.2
33
CLI transmitting Function No.: 19
Set this item to enable/disable identification of a telephone line calling from a GSM
network. The function can be enabled if you have a device on your telephone line
that is capable of receiving FSK according to ETSI standards.
Setting options: Disable -EasyGate does not transmit the CLI.
FSK during ringing -EasyGate transmits the FSK-
based CLI according to the ETSI EN 300 659 standard
(transmission during ringing).
Tbd.
- prepared for future use
Default setting: Disable
Replace character + in CLI by Function No.: -
If this parameter is filled, the + character in the international prefix of CLI is
replaced by the defined string. The + character can neither be transmitted by the
FSK protocol nor dialed by the DTMF from a terminal.
Setting options: 0-15 characters (0-9,*,#)
Default setting: blank
Automatic call
BabyCall number Function No.: -
A number to be dialed for the automatic call function. If this item is blank, the
function is disabled.
Setting options: 0-15 characters (0-9,*,#,+)
Default setting: blank
BabyCall timeout [s] Function No.: -
Time between line Off-Hook and automatic call beginning (if enabled). During this
timeout EasyGate waits for dialing that cancels the automatic call. You can make
standard call if the BabyCall function is enabled.
Setting options: 0-15 s
Setting step: 1 s
Default setting: 0 s
FXS Routing Parameters
All parameters related to the number dialed for an outgoing call are arranged in this
table. According to the prefix you can:
„ Bar the number to be dialed - the calling subscriber hears the busy tone;
„ Accelerate connection establishing by knowing the number length for the
given prefix;
„ Accelerate connection establishing by allowing to terminate dialing with a #;
„ Modify the number to be dialed by removing and/or adding digits.
„ Set tariff metering for the given prefix.