2N Helios IP User manual, 1510 v1.12 - Manual (Page 113)

2N® Helios IP Control as Viewed by Internal User
4.3
113
4.3 2N
®
Helios IP Control as Viewed by
Internal User
This section describes the 2N ® Helios IP control as viewed by an internal user.
Receiving of 2N
®
Helios IP Calls
Incoming calls from 2N ® Helios IP can be received like any other call. You can open
the lock and activate or deactivate a user or profile during the call using your
telephone numeric keypad. The call duration is limited to avoid unintentional
2N
® Helios IP line blocking. Use the Call time limit parameter to set the maximum call
duration (refer to Miscellaneous). To prolong a call push the # button on your
telephone any time. A short beep 10 s before the call end signals an automatic all
termination.
Calling to 2N
®
Helios IP
2N ® Helios IP allows to answer an incoming call too. To set the required parameters
use the Incoming calls item, refer to Miscellaneous.
Code Door Opening (Switch Activation)
2N ® Helios IP is equipped with a door unlocking switch. To activate the switch enter
the valid code (see Miscellaneous) on the numeric keypad.
Procedure: Enter the lock 1 or lock 2 activating code using your telephone numeric
keypad and push * (confirmation is unnecessary if the Lock code without confirmation
option is selected, refer to Miscellaneous).
A valid code is announced by acoustic signalling . An invalid code is announced by
acoustic signalling
.
User Activation and Deactivation
You can activate or deactivate a user and define call routing to the user telephone
numbers using the numeric keypad. For more details refer to the Telephone Directory
subsection.
Procedure: Enter the user activation or deactivation code using the numeric keypad
and push * for confirmation.
A valid code is announced by acoustic signalling or depending on the code type.
An invalid code is announced by acoustic signalling
.