2N Helios IP User manual, 1510 v1.12 - Manual (Page 47)

Acoustic Signalling and Keypad Configuration 3.1
47
Switching to Default Network Parameters
– Dynamic
IP Address
Switching to the default network parameters with the dynamic IP address can be
performed in two ways. Either through a web interface as described in the Network
subsection or by pushing a combination of the quick dialling buttons as shown in
Figures 3.4–3.6. Upon resetting, the web server is automatically switched on if
switched-off before. The buttons have to be entered within 30 seconds after the
internal application launch as signalled by the
tone sequence. The maximum delay
between the buttons is 2 s.
Figure 3.4 Switching to Default Network Parameters – DHCP (Part Nos. 9137131E, 9137131CE,
9137131CKE)
Figure 3.5 Switching to Default Network Parameters – DHCP (Part Nos. 9137161E, 9137161CE,
9137161CKE)