2N Omega series - VoIP manual v1.4 User Manual
Page 15
Advertising
15
Connect the USB cable inserted to the J2 connector to make connection
with your PC.
While connecting the system for the first time, remember to install the USB-
COM driver (refer to the “data/OMEGA Lite/Cz/Software/VoIP/DriverUSB/” CD
attached). A new COM PORT is added after installation. After that you may
establish the HyperTerminal connection and perform the necessary settings.
Used for network parameter setting (IP address, network mask, etc.).
After the network parameters have been set up you may disconnect the
cable.
!
Advertising