2N SmartGate - User Manual - Manual (Page 23)

18
8. SmartGate Parameter Programming
Most of SmartGate’s parameters have such default values that meet most users’
demands and need not be changed. Usually you have to program routing tables
according to SmartGate usage. Use a PC with the PCManager installed for SmartGate’s
parameter programming.
8.1. PC based Programming
For programming, connect SmartGate to a PC with a serial cable and make sure that
the SmartGate PCManager is installed. Programming is intuitive and easy. All items and
parameters are accompanied with texts hints - just point at anything with the mouse
cursor.
SmartGate data uploading and storing, including firmware upgrade, are executed in a
special mode, in which SmartGate waits for about 3s after power up (all LEDs are on). If
instructed so by the PCManager during this timeout, SmartGate remains in this mode as
long as it is necessary. If SmartGate is not reset after the PCManager is terminated,
switch the system off and on again.
Language
selection
Data
handling
Programming
tables
Monitoring