2N SmartGate - User Manual - Manual (Page 38)

33
GSM routing table
Incoming calls from GSM contain the CLI. According to received CLI SmartGate can
do following:
· Reject the call;
· Route the call to FXS or FXO interface;
· Automatic dial in. SmartGate dials preprogrammed PBX subscriber number (for
example switchboard operator) to be connected with calling GSM subscriber.
FXS line Off-Hook to DISA timeout [ms]
Timeout between FXS line Off-Hook and automatic dial in according to parameter
"Dial in" in the table.
Setting options: 100-25500 ms
Setting step: 100 ms
Default setting: 2000 ms
FXO line Off-Hook to dial-in timeout [ms]
Timeout between FXS line Off-Hook and automatic dial in according to parameter
"Dial in" in the table.
Setting options: 100-25500 ms
Setting step: 100 ms
Default setting: 1000 ms
CLI – calling number
Fill in CLI, to route the call according to parameter on the same table line. It is
possible to fill in only prefix for group of CLI's. If parameter "Substring" = 0, you
must fill prefix as you see it on display of your mobile phone - It means inclusive
of + and international prefix if they are included. If parameter "Substring" > 0,
SmartGate searches filled prefix as substring of the received CLI, but max. to
position given by "Substring" parameter. Positions are counted from zero. See
examples in "Substring" parameter hint.
Setting options: 0-16 characters (0-9,*,#,+)
Default setting: blank
Substring
Parameter is used to make filling CLI prefix easier. If parameter "Substring" > 0,
SmartGate searches filled prefix as substring of the received CLI, but max. to
position given by "Substring" parameter. Positions are counted from zero.
for example received CLI +420603198222 corresponds with settings:
CLI - calling number
Substring
+420603198222 any setting
+420603 any setting
+420 any setting
603198222 4, or more
603 4, or more
Setting options: 0-15
Step:
1
Default setting: 0