2N SmartGate - User Manual - Manual (Page 7)

2
2. Installation
2.1. Proper Location
· SmartGate is designed for vertical mounting on suspension holes (use the mounting
pattern). This position is the best for signal reception because a vertical antenna is
used. SmartGate can be operated in the horizontal position too where the GSM
signal is good or with antenna connected on coax cable.
· Install SmartGate with respect to the GSM signal strength – check the signal strength
using the PCManager.
· Place SmartGate out of range of sensitive devices and human bodies for
electromagnetic interference reasons.
· SmartGate can disturb other telecommunication systems. Place phone lines and
connected terminals and PBX’s faraway from antenna.
· For the allowed range of operating temperatures refer to the “Technical
Parameters”.
· It is impossible to operate SmartGate on sites exposed to direct solar radiation or
near heat sources.
· SmartGate is designed for indoor use. It may not be exposed to rain, flowing water,
condensed moisture, fog, etc.
· SmartGate may not be exposed to aggressive gas, acid vapours, solvents, etc.
· SmartGate is not designed for environments with high vibrations such as means of
transport, machine rooms, etc.