Monitoring, Common settings, Snmp – 2N VoiceBlue MAX v1.2 User Manual
Page 73
73
Monitoring
This section helps you configure sending of SNMP traps. Download the list of available
traps, i.e. the MIB table, from the gateway web interface. The main purpose of SNMP
monitoring is to observe your GSM gateway states continuously and send state
information to the defined IP addresses whenever an error occurs.
Refer to the
for the list of all SNMP traps sent by
List of SNMP traps
2N VoiceBlue
®
.
MAX
Caution
This
service
is
subject
to
licence!
Refer
to
for the current GSM gateway
Management–>Licence key
licence state details.
Common Settings
General
define the maximum/minimum level of the signal received by the
Signal level –
GSM/UMTS module. The SNMP trap is sent automatically whenever the defined
values are exceeded.
– define the maximum filling capacity of the SMS
SMS bufer upper limit
storage. The SNMP trap is sent automatically whenever the defined value is
exceeded.
SNMP
General
– enable/disable the SNMP service.
Enabled
– SNMP community is a group that owns the device and control
Community
stations on which SNMP is running. Default value = public.