ADS-TEC OPC8013/8015/8022 - Manual (Page 10)

OPC8013/OPC8015/OPC8022 9
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
2 Operating and safety instructions
The device operates under electrical voltage and contains highly sensitive components. Intervention by
the user is required only for connecting the power supply lines. Should any further modifications be
required, it is necessary to consult either with the manufacturer directly or with service personnel
authorised by the manufacturer. The device must be de-energised during work. Appropriate measures
must be taken to prevent electrostatic discharges on components. If the device is opened up by an
unauthorised person, the user may be subject to hazards and the warranty is invalidated.
General information

All users must read this manual and have access to it at all times.

Installation, commissioning and operation may only be performed by qualified
and trained personnel.

The safety notices and the manual itself must be observed by all persons who
work with this device.

At the installation site the valid guidelines and regulations for accident
prevention must be observed.

The manual contains the most important instructions on how to use this device
in a safe way.

Appropriate storage, proper transport, installation and commissioning, as well as
careful operation are prerequisites for ensuring safe and proper operation of the
device.

The device can be cleaned by using a soft cloth and a commercially available
glass cleaning agent (e.g. Sidolin) with low alcohol content.
ATTENTION
To prevent damage to the device, all cable lines
(power supply, interface cables) must be only be
connected while the device is switched off.
2.1 Operating location
The control system is designed for use inside a switching cabinet. Make certain that the specified
environmental conditions are maintained at all times. Use in non-specified environments, i.e., on board
ships, in explosive atmospheres or at extreme elevations, is prohibited.
ATTENTION
The device may only be switched on after
acclimatising to the ambient temperature in order
to avoid condensate accumulation. This also
applies if the device is exposed to extreme
temperature fluctuations.
To avoid overheating in operation: The device
must not be exposed to direct radiation by
sunlight or any other light source.
ATTENTION
If the device is installed in a panel, casing or
similar, it must be ensured that no heat
accumulation occurs. The maximum permissible
ambient temperature must not be exceeded.