ADS-TEC OPC8013/8015/8022 - Manual (Page 7)

OPC8013/OPC8015/OPC8022 6
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
1.7 Standards
This device is compliant with the provisions and safety objectives of the following EU directives:
Standards

This device is compliant with the CE mark test requirements as defined in the
European test standards EN 55022 and EN 50082-2

This device is compliant with the DIN EN 60950 (VDE0805, IEC950) testing
specifications on “Information technology equipment – Safety"

This device is compliant with the DIN EN 60068-2-6 testing specifications
(sinusoidal vibration)

The device is compliant with the DIN EN 60068-2-27 testing specifications
(shock resistance test)
Information:
A corresponding declaration of conformity is available for competent
authorities at the manufacturer and can be viewed upon request.
For full compliance with the EMC legislation, all components and cables
used for device connection must also be compliant with these requirements.
It is therefore necessary to employ BUS and LAN cables with shielded
connectors and these must be installed as per the instructions contained in
the user manual.
1.8 Scope of delivery
Please check that all of the following components are contained in the packaging:

1 x device

1 x 3-pole lead-through connector from Phoenix Contact; 3-pole screwable 3.81
OPC7 (already plugged into device socket)

QuickStartGuide
Optional scope of delivery:

Operating system