15 rssi led threshold – AirLive AirMax5 User Manual
Page 62
4. Web Management-Wireless and WAN Settings
55
AirLive AirMax5 User’s Manual
Step 1. Enable Bandwidth Control and select “Per User Bandwidth Control”
Step 2. Enter Description for this policy (Wireless Client)
Step 3. Select “MAC Address”, then enter the MAC address of the wireless client.
Step 4. Enter the downlink speed as “1024” and uplink speed as “512”.
Step 5. Click on “Add” button to add the bandwidth policy
Step 6. This new policy should appear on the button. You can enable/disable it.
4.2.15 RSSI LED Threshold
Operation Mode -> Setup -> RSSI LED Threshold
The AirMax5 is equipped with 2 LEDs to indicate the signal strength of current connection.
It is very useful in helping you to align the antenna. The signal level are classified into 4
levels, you can change the Thresholds (dividing line) between levels in this setting.
Please note that the smaller the absolute value of RSSI is, the stronger the signal. For
example, -50dB is stronger than -80dB. RSSI level stronger with -60dB is considered a
very good connection. This setting only appears in Client and Bridge modes.
No Signal: When signal strength is less than “Weak Signal Threshold” (i.e. 85dB).
Both LED are off.
Weak Signal: When signal strength is greater or equal than the “Weak Signal
Threshold” (i.e. -75dB). Only the Blue LED is on.